Precautions and Recommendations
Do not use below 5ºC or above 30ºC.
Do not use in areas with a risk of frost, rain, strong winds, or direct sunlight.
Do not use in areas at risk of standing water.
For claddings over 30 m², leave expansion joints filled with a deformable material.
For interior claddings with an area over 15 m², it is recommended to leave a perimeter expansion joint between the cladding and the wall or pillar located behind the recessed base.
To ensure perfect adhesion, avoid moving the tiles over the tiles for 3 or 4 days.
Maximum weight for vertical cladding: 40 kg/m².
On facades and exterior walls, the material should always be installed using anchors or mechanical fixing.
Presentation
20 kg laminated paper bags.
Storage for up to 1 year in the original packaging, protected from weather and humidity.
Technical Data
(Statistical results obtained under standard conditions)
Appearance: WHITE
Mixing water for white product: 24 ± 2%
Mixing water for gray product: 27.5 ± 2%
Apparent dust density: 1.5 ± 0.2 g/cm3
Mixed product density: 1.8 ± 0.2 g/cm3
Adjustment time: Approximately 30 minutes (depending on climatic conditions)
Paste pot life: Approximately 2 :30 h (Depending on climatic conditions)
Initial adhesion > 0.5 N/mm²
Adhesion after water exposure > 0.5 N/mm²
Adhesion after aging under heat > 0.5 N/mm²
Adhesion after freeze-thaw cycle > 0.5 N/mm²
Classification according to NF EN 12004: 2001 C1 T
Approximate coverage 15 kg/m² per cm of thickness
Application thickness: Allowable between 0.5 and 2 cm
Note
The instructions in this manual are based on our tests and knowledge, and do not imply any commitment on the part of SARL RITAL or release the consumer from the responsibility of checking and verifying the products for their correct use. Claims must be accompanied by the original packaging to allow for proper traceability.
SARL RITAL assumes no responsibility, under any circumstances, for the application of its products or construction solutions by the application company or other parties involved in the application and/or execution of the project in question. RITAL's liability is limited exclusively to possible damages directly or exclusively attributable to the products supplied, individually or integrated into systems, due to manufacturing defects.
C1E
