• product photo
  • product photo

COARSE FILLER COATING 611

Note

 

The instructions in this manual are based on our tests and knowledge, and do not imply any commitment on the part of SARL RITAL or release the consumer from the responsibility of checking and verifying the products for their correct use. Claims must be accompanied by the original packaging to allow for proper traceability.

 

SARL RITAL assumes no responsibility, under any circumstances, for the application of its products or construction solutions by the application company or other parties involved in the application and/or execution of the project in question. RITAL's liability is limited exclusively to possible damages directly or exclusively attributable to the products supplied, individually or integrated into systems, due to manufacturing defects.

 

S'identifier
  • Description
  • Vidéos
  • Fiches techniques
  • Plus d'informations

  • Note

     

    The instructions in this manual are based on our tests and knowledge, and do not imply any commitment on the part of SARL RITAL or release the consumer from the responsibility of checking and verifying the products for their correct use. Claims must be accompanied by the original packaging to allow for proper traceability.

     

    SARL RITAL assumes no responsibility, under any circumstances, for the application of its products or construction solutions by the application company or other parties involved in the application and/or execution of the project in question. RITAL's liability is limited exclusively to possible damages directly or exclusively attributable to the products supplied, individually or integrated into systems, due to manufacturing defects.

     

    • Comment utiliser:

      Application method

      Mechanically mix Landoy Du Charge Gro 611 powder with water until a homogeneous, lump-free paste is obtained.

      Leave it to set for 10 minutes before application.

      Generously fill cracks or holes using a metal scraper.

      Pass the mortar crosswise so that the plaster penetrates to the bottom of the crack.

      Smooth the surface using a plastering blade.

      After checking that the mortar is completely dry, lightly sand the surface with sandpaper.

Notre selection

ADHESIVE CEMENT C1
S'identifier
ADHESIVE CEMENT C1 GREY
S'identifier
ADHESIVE CEMENT C1E
S'identifier
ADHESIVE CEMENT EXTRA C2
S'identifier
COARSE FILLER COATING 611
S'identifier
WATERPROOF COATING 510
S'identifier
ADHESIVE CEMENT Flex C2 TE S1
S'identifier
SINGLE-LAYER MORTARS
S'identifier
JOINT COMPOUND 1-3-5 KG
S'identifier